SURFACE PREPARATION

Surface preparation is very important so that the epoxy paint can show the expected performance. The surfaces to be applied must be free rust, from oil, dust, grease and dirty. It is especially recommended to sandblast at least Sa 2½ degree according to Swedish standard SIS 05 59 00 for surface cleaning. Abrasives provided surface roughness Medium G 30-85 micron degree ISO 8503-2 should be used.

MIXING PREPARATION

A and B component should be mixed with a low speed mixer for at least 3-4 minutes until a homogenous mixture is obtained by paying attention to mixture ratios. It is ready for application after mixing.

COATING SYSTEM

It can be applied by brush, roller and spray. Thinner is used for thinning in application by spraying on metal surfaces. Paint thinned to viscocity at 18-20 sn /DIN CUP4/ 20°C should be applied to metal surfaces as one or two coats with a total dry film thickness of 30-35 micron. The mixture prepared by application with brush or roller is applied without thinning.

APPLICATION CONDITIONS

* Avoid application in very humid environments and below 10°C. Products that can be used under this product:

* AC 070 Epoxy Zinc Rich Prime

* AC 080 Surface Tolerant EpoxyPrime Products that can be used upper this product:

* AC 6390 Epoxy Top Coat Paint For Metal Surfaces