SURFACE PREPARATION

* The surfaces to be applied should be free from oil, dust and dirty.

* Free parts on the surface should be cleaned.

* The parts on the surface that prevent adhesion should be cleaned.
Yüzeydeki serbest parçalar temizlenmelidir. 
Yüzeylerdeki yapışmaya engel olan parçalar temizlenmelidir.

MIXING PREPARATION
A and B component should be mixed with a low speed mixer for at least 3-4 minutes until a homogenous mixture is obtained by paying attention to mixture ratios. According to the surface properties and color type to be applied, add the coloring C component into the A + B mixture and mix again until the color is homogenous and optionally add 5% water to the total amount of product to ready for application.

APPLICATION
Mixed product should be used at least within 2.5 hours. Otherwise, the product will show a chemical reaction and harden and will not be recycled. After the product is applied, it is 24 hours to fully dry and open to light pedestrian traffic

APPLICATION CONDITIONS

* Avoid application in very humid environments and below 10°C.

* Mixing ratios should be considered.

* During application and after application, the soil should be protected from adverse weather conditions such as rain, hail and snow for 24 hours.

VOC REGULATION 2004/42 VOC DECOPAINT DIRECTIVE
The maximum permissible volatile organic compound (VOC) content (product category IIA / j type WB) is 140 g / L (2010 limit) according to EU-Directive 2004/42. The maximum VOC content of the POWER CONCRETE/ASPHALT PAINT ready to use is <140 g / L.