SURFACE PREPARATION

The surfaces to be primed need to be cleared of all types of rust, roller shell, dirt, dust, oil and grease. Sand blasting at least SA 2½ level, in accordance with the Swedish standard SIS 05 59 00, is especially suggested for surface cleaning. For surface roughness, abrasives should be used to provide Medium G 30-85 micron level and meet ISO 8503-2.

MIXTURE PREPARATION

Using a low speed mixer, it should be mixed for at least 3-4 minutes to attain an homogeneous mixture while paying attention to A and B component mixture rates. It is ready for application after mixing.

COATING SYSTEM

It can be applied using a brush, roller or blasting. In application using blasting, thinner is used for thinning. The paint thinned at20°C for 18-20 secs to /DIN CUP4/ viscosity can be applied on metal using a gun to provide 35-40 micron dry film. The mixture prepared by brush or roller does not need thinning before moving on to application.

APPLICATION CONDITIONS    

*Application should be avoided below 5°C and in extremely humid conditions

* Yellowing may occur when subjected to direct sunlight however it doesn’t

* adversely impact the product’s prevention performance.

Products suggested to be used under this product:

* PRIMER SC 215 Epoxy Primer without solvent

* PRIMER SC 270 Low viscosity Epoxy Impregnated Prime