SURFACE PREPARATION

Y Free particles and paint residues on the surface must be thoroughly cleaned, brokens and cracks must be repaired, surfaces should be roughened mechanically (blastrack or milling router) and cleaned from vacuum with vacuum cleaner. After priming with SC 215 Solvent Free Epoxy Primer or SC 270 Low Viscosity Impregnated Primer, application should be started.

MIXING PREPARATION
A and B component should be mixed with a low speed mixer for at least 3-4 minutes until a homogenous mixture is obtained by paying attention to mixture ratios. It is ready for application after mixing.

COATING SYSTEM
Depending on the suction power of the surface, the primer waste varies between 0,300 and 0,800 kg/m².

APPLICATION CONDITIONS

* Surface should have sufficient strength. The concrete should have a compressive strength of at least 25 N/mm² and a tensile strength of at least 1,5 N/mm².

* The SC 200-K self leveling intercoat prime should be completed its curing before the top coat coating is started.

* Avoid application in very humid environments and below 5 ° C.

* Mixing ratios should be considered. Products that can be used upper this product:

* SC 650 ST Solvent Free Epoxy Resin Based Top Coat Coating

* SC 605 Epoxy Top Coat Paint for Vertical Surfaces

* SC 645 Orange Coat Patterned Top Coat Epoxy Coating

* SC 800 Hygienic Epoxy Top Coat Coating and Paint for Potable Water Reservoir

* SC 902 Solvent Free Epoxy Top Coat Coating

* SC 905 Solvent Free Epoxy Paint Resistant to Chemical Matter for Vertical Surfaces

* SC 950 Solvent Free Epoxy Coating Resistant to Chemical Matter