SUPER CONCRETE ULTRA SHINE
DEFINITION
Nano technological lithium silicate surface protector and hardener which can be used on all concrete surfaces, prevents the powder, increases the strength of concrete surface and has high gloss
Public Works Pos. No: 04.379/F01
USAGE AREAS
New or old concrete surfaces, cement based mineral surfaces, storage areas, factories, factories, multi-storey car parks, airplane hangars, work place buildings, cold storage warehouses, food industry factories, pharmacy stores, laboratories and all enterprises with concrete floors.
ADVANTAGES
-
Easy to apply.
-
High penetration capability (2-8 mm from the surface).
-
Water-based.
-
Contains nanotechnological lithium silicate.
-
Provides maximum anti-dusting and a high-gloss finish on concrete surfaces.
-
Creates a high-mechanical strength, polished concrete surface.
-
Prevents efflorescence (salt blooming), flowering, and staining.
-
Penetrates deeply into the concrete, reacting chemically with the lime in the concrete structure to form an insoluble bond on the surface.
-
Allows the concrete surface to breathe (vapor permeable).
-
Easy to maintain and clean.
-
Extends the service life of the concrete.
-
Environmentally friendly and safe for human health thanks to its low VOC content.
|
Colour |
Transparent |
|
Outlook |
Bright |
|
Thinner |
Ready to use |
|
Solid Matter by Weight, % |
16 |
|
Density Surface penetration |
1,11 gr/cm3 2- 8 mm |
|
Waste |
Between 50 gr–150 gr / m2 at single coat depending on the roughness and suction condition of the application surface. |
|
Package |
5, 10, 20 kg in plastic bins |
|
Application Methods |
brush, roller, air or airless gun |
|
Application Temperature |
It should be applied at temperatures above 10 ºC. |
|
Shelf Life |
1 yeat |
|
Drying Time Waiting time between coats |
1-2 hours /25 °C 10-15 minutes without product deposit (wet damp appearance |
|
Equipment Cleaning |
Water |
SURFACE PREPARATION
The surface to be applied must be completed its curing for 28 days. The surface must be cleaned from oil, dirt, rust, dust and all kinds of residues. Acid-containing cleaners should not use since it will degrade the surface properties of the concrete floor to be applied.
APPLICATION CONDITIONS
The product is ready for use and the roughness is mechanically removed or impregnated directly onto the polished concrete surfaces with a brush roller or soft microfiber pads. The product should be distributed homogeneously so as not to cause ponding on the surface. It can be used as a protective top coat to increase the shine and water impermeability on finished surfaces mechanically polished. Upon final application, polish with wool pens can be made. The applied surface should be protected from rain or snow for at least 72 hours. The maximum water resistance and stain resistance of the product should be tested after at least 7 days. Further cleaning of the applied surfaces with non-acidic (Ph 7) cleaning products for subsequent maintenance and cleaning will ensure the mechanical and luster performance of the product for many years. Surface cleaning should be done with microfiber pads and dry powder pad.
